Agricultural Robotics Using Absolute Position Sensors on a Zero Turning Radius Platform

Show simple item record

dc.contributor.advisor Gary Roberson, Committee Member en_US
dc.contributor.advisor Mike Boyette, Committee Chair en_US
dc.contributor.advisor Larry Stikeleather, Committee Member en_US
dc.contributor.advisor Doug Barlage, Committee Member en_US
dc.contributor.author Powell, Nathaniel B en_US
dc.date.accessioned 2010-04-02T17:54:45Z
dc.date.available 2010-04-02T17:54:45Z
dc.date.issued 2007-05-04 en_US
dc.identifier.other etd-03292006-174958 en_US
dc.identifier.uri http://www.lib.ncsu.edu/resolver/1840.16/333
dc.description.abstract Autonomous field equipment which can successfully replace human operators on tractors and other equipment may revolutionize agriculture. Replacing current field equipment such as large tractors with autonomous machines designed so that one person can supervise multiple machines will make it possible to use more machines without increasing the number of human operators needed. This makes it feasible to use smaller machines, which have benefits for cultivation, safety and the cost of purchasing and maintaining the equipment. This research is a step in the process of developing autonomous equipment. Using a zero turning radius vehicle, a prototype autonomous vehicle was constructed which measures position with a differential global positioning system (DGPS) receiver. A real time kinematic GPS (RTK-GPS) receiver was used for development and testing to obtain the most accurate results available. This work built upon previous autonomous navigation work using different sensors including a laser positioning system and a machine vision system. In addition to the GPS receiver an electronic compass was used to aid with turning behavior. These sensors were coordinated using inexpensive microcontrollers as input processors and a third microcontroller to coordinate the inputs and control the machine by controlling electronic actuators installed on the steering mechanisms. A simple control algorithm was implemented by combining the crosstrack and angular deviations from the reference path and applying a control input to the actuators based on that combined or "aggregate" error. The control input was calculated using a the traditional Proportional-Integral-Derivative controller. The system was developed and tested on a flat grassy lawn bordered by trees and buildings which provided an ideal simulation of a landscape management application. A straight line path 45 meters in length was set up for testing the machine. The machine started at one end of this path and navigated to the other end. The performance was measured by recording the position reported by the RTK-GPS on a handheld computer and calculating the crosstrack error between the recorded position and the straight line path. The results demonstrated that the autonomous navigation system was able to navigate the machine from point to point. The performance did not meet the desired standards of precision and was characterized by oscillations which were of higher amplitude and higher frequency than is acceptable for agricultural machines. Limitations in the microcontrollers' ability to store and manipulate the position data were a major factor. However, the potential of small zero turning radius platforms for agricultural robotics is significant and the simplicity of controlling such vehicles is a great advantage over traditional tractors. en_US
dc.rights I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to NC State University or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. en_US
dc.subject GPS en_US
dc.subject mobile robot en_US
dc.subject agriculture en_US
dc.subject en_US
dc.title Agricultural Robotics Using Absolute Position Sensors on a Zero Turning Radius Platform en_US
dc.degree.name MS en_US
dc.degree.level thesis en_US
dc.degree.discipline Biological and Agricultural Engineering en_US


Files in this item

Files Size Format View
etd.pdf 1.303Mb PDF View/Open

This item appears in the following Collection(s)

Show simple item record